Over 20 years of plumbing teaches you that most bath and shower faults have been misread before anybody calls. In Royal Tunbridge Wells that means valves replaced for a cold shower that was really an immersion fault, and trays lifted for a leak that was a failed seal. Bath And Shower Repair goes quicker, and cheaper for you, when the diagnosis comes first.
Key Points
- Why the hot water supply is checked before any shower valve
- Which electric shower parts are repaired and when the unit is replaced
- Where a leak under a shower tray actually comes from
- Why a bath is filled with water before it is resealed
- The order the job runs in, from first call to final test
Vision Plumbing is a sole trader plumbing, drainage and hot water business. The plumber who looks at your shower is the one who quotes it, fixes it and answers for it, and the same man handles drain cleaning in Royal Tunbridge Wells with his own equipment.
Get a quick quote from Vision Plumbing in Royal Tunbridge Wells and have the fault found before anything is replaced.

Checking the Hot Water Supply First
Plenty of shower faults start somewhere else. A mixer or thermostatic shower can only blend the hot water it is given, so a shower that runs lukewarm is often a cylinder or immersion problem, not a valve problem. We check the supply before we strip anything.
The order is fixed:
- Run the bath hot tap and note the temperature and the flow.
- Check the immersion heater: thermostat setting, wiring and connections, and whether the element is drawing.
- Only then open the shower valve.
That sequence matters to you because it stops a good valve being replaced to cure a bad element. Domestic immersion heaters run from the standard electrical supply, with an off-peak setup as an option, and repairing or replacing one is work we do. If your hot water comes from a gas appliance, that side is a registered gas engineer's job. We tell you at the first visit, not halfway through.
Get a quick quote from Vision Plumbing for Bath And Shower Repair in Royal Tunbridge Wells, from a surging thermostatic valve to a cracked bath swapped out like-for-like.

Electric Shower Repairs in Royal Tunbridge Wells
An electric shower is a tankless water heater on the wall. Cold mains water passes over a heating element in a small heater can and comes out hot. No cylinder. So the faults are its own.
Electric shower faults
The common ones are a burnt-out element, a thermal cut-out that keeps tripping, a pressure relief device that has operated, a failed microswitch or solenoid, and limescale packed into the heater can and the shower head. Each gives a different symptom. Cold water only. Water that goes hot then cold. No flow at all.
Repair or replace
A cut-out, a relief device, a microswitch or a solenoid can be replaced as a part. A cracked heater can, a unit with no parts left, or one that has failed more than once usually means a new shower. A like-for-like replacement on the same rating keeps the existing supply, which keeps the job contained.
Pumped showers
Where a shower runs off a pump, low pressure can be the pump, its impellers or an airlock, not the shower. We test the pump on its own before deciding. Across Royal Tunbridge Wells and the towns around it the method does not change, and a shower repair in Sevenoaks follows the same order of checks.

Valves, Trays, Seals and Baths
Past the hot water source, a bath and shower repair comes down to valves, seals and fittings. Both fittings get the same attention.
Mixer and thermostatic valves
A thermostatic valve that surges hot or cold usually has a scaled or worn cartridge, a blocked filter or a stuck check valve. Cartridges are replaceable. A valve body that is cracked, or one where no cartridge is available, is replaced instead.
Leaking trays
Water under a shower tray comes from one of three places: the silicone seal, the waste joint or a cracked tray. We find which before anything is lifted. A failed seal is cut out and redone. A cracked tray is swapped.
Baths: taps, wastes, resealing and cracks
- Dripping taps: washers or ceramic cartridges replaced.
- Leaking wastes and overflows: joints remade or the waste replaced.
- Resealing: old silicone cut out, the joint cleaned and dried, and the bath filled with water before sealing so the bead sets at its loaded position.
- A cracked bath: swapped like-for-like into the same space.
That filled-bath step is why a reseal holds when you next sit in it.

Installation and Repair Process
You deal with one plumber from first call to last tap. Vision Plumbing is Norbert, and he quotes the job and does it. Nobody else turns up. Nobody passes it on.
The job runs in this order:
- We talk through the fault and agree a visit.
- We diagnose on site, supply first, then the fitting.
- We tell you whether it is a repair or a replacement, and why.
- You get the quote before any work starts.
- We do the work, test it under use, and leave it running.
Every job carries a one year warranty on parts and labour, and the man who gave it is the man you ring. Our shower fitting work is replacement of a failed fitting, not a bathroom refit. A bath that drains slowly sometimes points past the waste, and that becomes drain unblocking in Royal Tunbridge Wells, done with the same care. Water coming through a ceiling at night needs an emergency plumber in Royal Tunbridge Wells on the 24-hour call-out. And from here to a shower installation in Maidstone, it is still Norbert who arrives. Get a quick quote and the next step is a conversation, not a form.
We take on shower fitting services too.
Get a quick quote from Vision Plumbing for Bath And Shower Repair in Royal Tunbridge Wells, from a surging thermostatic valve to a cracked bath swapped out like-for-like.
Bath And Shower Repair in Royal Tunbridge Wells: Your Questions Answered
Do plumbers fix bathroom leaks?
Yes, and most bathroom leaks are plumbing faults. A dripping tap, a weeping waste joint, a failed seal round a bath or tray, or a leaking shower valve are all work we repair. We find the source first, so nothing is lifted or replaced until we know where the water is coming from.
How expensive is it to fix a shower leak?
It depends entirely on the cause. A failed silicone seal and a cracked shower tray are very different jobs. We do not quote prices before we have seen the fault. We diagnose it, tell you whether it is a repair or a replacement, and give you the quote before any work starts.
Do you cover all of Royal Tunbridge Wells?
Yes. We cover Royal Tunbridge Wells and the towns around it, across Kent, East Sussex and the wider area round Sevenoaks. Wherever you are in town, the same plumber quotes the job and does it. Get a quick quote and we will arrange a visit.
Can you replace a cracked bath in Royal Tunbridge Wells without refitting the bathroom?
Yes. We swap a cracked bath like-for-like into the same space, reconnect the taps, waste and overflow, then reseal it with the bath filled so the seal sets at its loaded position. It is a fitting replacement. No refit. The work carries our one year warranty on parts and labour.


